WallBox Power Boosts

Power Boost balances the available energy dynamically among the charger and the rest of the devices in the house. This helps you to avoid exceeding your infrastructure’s available power and prevents blackouts.

Power Boost is an additional feauture to your Electric Vehicle charger. It is fully compatible with the Pulsar Plus range we offer on other listings.

• Intelligent charging - Measures how much electricity your house consumes and uses the rest for your car.
• Charge your vehicle safely - Protect your building’s electric installations and the local grid.
• Optimise power usage - Always charges at maximum power available.

Product codes

Power Boost Clamp, 1 phase 100A / SPM1-100-AC/Temco  - Clamp Only

Power Boost Meter, 1 phase 100A / EM112 / Carlo Gavazzi (single phase meter)

Power Boost Meter, 3 phase 65A / EM340 / Carlo Gavazzi

Power Boost Meter, 3 phase 250A / EM330 + 3 Clamps 250A / Carlo Gavazzi

As shown in figure below, the meter must be located after the utility meter and mains switch and before the separation to the house loads. Install the energy meter to the mains according to its installation manual. The charger communicates with the energymeter through a cabling system that consists of three wires. The installation manual of the delivered energy meter describes where to connect the cabling.

You can configure Power Boost via the Wallbox App. Log-in to the Wallbox App, approach the charger, wait until the Bluetooth is synchronized. Then select "Power Boost" inside the settings menu for configuring the parameter.